Spindle RPM is inversely proportional to tool diameter. Smaller end mills (e.g. 1/8" or 3 mm) require significantly higher RPM to achieve the required Surface Feet per Minute (SFM), whereas large face mills run at lower RPM to avoid overheating the cutting edge.
Why is 75% thread engagement recommended for tapping?
A 75% thread engagement provides nearly 100% of full thread shear strength while dramatically reducing tapping torque and the risk of breaking taps in expensive workpieces, especially in tough alloys like stainless and titanium.
What is Radial Chip Thinning and when should it be considered?
When taking light radial stepovers (less than 50% of cutter diameter), the actual chip created is thinner than the programmed advance per tooth. To maintain optimal chip thickness and prevent rubbing, the feed rate must be increased.