The Dener TTH-10 is an industrial-grade CNC Lathes & Turning Centers powered by the Standard CNC. a top spindle speed of 3,500 RPM, and a 3-axis kinematic layout. It supports standardized digital factory monitoring via MTConnect.
Dener TTH-10 CNC lathe: 10 inch chuck, 3,500 rpm, 92 mm spindle bore, 75 mm bar capacity, 528 mm turning diameter, 660 mm machining length.
| Standardized Parameters & Ratings | |
|---|---|
| Manufacturer (Brand) | Dener (International) |
| Machine Type | CNC Lathes & Turning Centers |
| CNC Controller System | Standard CNC |
| Number of Controlled Axes | 3-Axis Simultaneous / Positioning |
| Maximum Spindle Speed | 3,500 RPM |
| Spindle Motor Rating | 11.0 kW |
| Spindle Taper Interface | Standard |
| Industrial IoT Protocol | MTConnect ANSI/MTC1.4 Compliant (Ethernet/TCP) |
| Rapid Traverse Xz | 30/30 m/min |
| Cutting Feed Rate Xz | 1~10 m/min |
| Swing Diameter | 650 mm (25.6 in) |
| Max Turning Diameter | 528 mm (20.8 in) |
| Max Turning Length | 660 mm (26 in) |
| Chuck Size | 10 inch (254 mm) |
| Max Spindle Speed | 3,500 rpm |
| Spindle Motor Power | 11/16.5 kW |
| Spindle Bore | 92 mm (3.6 in) |
| Bar Capacity | 75 mm (3 in) |
According to secondary market equipment benchmarks for November 2026, the Dener TTH-10 is estimated between $36,000 and $74,000 USD depending on machine hours, spindle condition, and tooling package. Financing and industrial lease options typically start around $558 / month.
Bar capacity is 75 mm (3 in) through a spindle bore of 92 mm (3.6 in). An automatic bar feeder unit is listed under optional equipment, as is a part catcher.
The TTH-8 has an 8 inch (203 mm) chuck, 4,500 rpm, 52 mm (2 in) of bar capacity and 15/24.2 kW. The TTH-10 has a 10 inch (254 mm) chuck, 3,500 rpm, 75 mm (3 in) of bar capacity and 11/16.5 kW, on the same swing and turning diameter.
Maximum turning diameter is 528 mm (20.8 in) and machining length 660 mm (26 in). The swing diameter over the bed is 650 mm (25.6 in).
The page does not say. It prints 11/16.5 kW for the TTH-10 and gives no torque or gearing data, so the figure should be checked with Dener before the machine is chosen for heavy cuts.
Peer engineering insights, spindle reliability feedback, and real-world shop floor experiences.